top of page
Section Scope on where to Create Openings
Introduction
Introduction
In this session, you will learn how to set the scope of where to adopt and update openings, whether it be in the entire model or within a specific part or level.
Video Tutorial
Video Tutorial
Adopt and Update Openings in a Floor- or Ceiling Plan
2D View
If you want to adopt and update openings in a Floor- or Ceiling Plan, open a 2-D View and reduce the visible area by activating the Crop-View if necessary. This will allow conVoid to adopt and update openings based on the displayed active view.
Adopt and Update Openings in a 3-D View
3D View
You can also adopt and update openings in your entire model or just a part of it. Herefore open a 3-D View, activate and adjust the Section-Box to reduce the visible section. ConVoid will now automatically adapt openings according to the elements visible in the view.
bottom of page